Mio C710 User Manual download pdf (Page 47)

4.6.1.3 Built-in cameras

Some cameras are built in traffic lights. They work like fixed cameras, but they are

difficult to spot. The warning for proximity and speeding is the same as for the fixed

cameras.

These cameras are displayed with the following symbol:

4.6.1.4 Section control cameras

These cameras work in pairs, and do not measure your current speed but your

average speed between the two cameras. Both will identify your car, and record the

exact time you pass them. The difference between the two points of time will be used

to calculate your average speed.

MioMap will warn you when you approach one of these cameras, but as you pass

by, the warning stays on, and your average speed is measured until you reach

another camera of this type. If your average speed exceeds the speed limit between

the two cameras, you will receive the same special warning sound as with the other

camera types.

Note: In the rare case MioMap cannot register the moment you pass the second

camera (e.g. it is placed at the exit of a tunnel where GPS position is not yet

available) the warning will continue. Just tap the camera symbol displayed on the left

to stop the warning.

These cameras are displayed with the following symbol:

4.6.2 Controlled traffic direction

The different cameras can measure the speed of one direction of the traffic, both

directions, or even several directions in an intersection, when they are mounted on a

rotating base. MioMap warns you only if you drive in a measured or possibly

measured direction.

The measured direction of the cameras are displayed with the following symbols:

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 83 84

No comments

Mio C710 User Manual Page 47